Accommodations and Layout Fine wood cabinetry and cabin sole, master V-berth forward. Head/shower to port, further aft portside U-shaped dinette converts to double berth. Starboard side settee converts to 2 berths, starboard aft Navigation Station with full compliment of navigation gear. Center aft, under companionway stairs, engine access.
Galley
Luke Heritage gimbaled 3 burner propane stove/oven
Stainless dual sinks with bronze hand pumps for fresh and salt water
Huge electric refrigerator with 2 compartments
Electric hot water
Lots of storage
Deck and Hull
Wheel steering
Teak, self bailing cockpit
Engine gauges
Vane steering
Grace autopilot
Davits for Argentina Battella inflatable w/stern stored 5hp 4-cycle outboard motor
Life lines, stainless pulpits and rails
NO TEAK DECKS
Aluminum spars and stainless rigging
Cockpit sun shade
Boom tent
Sail covers
Windlass forward
Multiple anchors including Turkish super holding anchor with rode
Engine Room/Mechanical/Electrical
49 HP Perkins Diesel 3300 hours
Electric hot water heater
Electric and manual bilge pumps
Force 10 cabin heater
Duotherm A/C
12V Fans
Reading lamps
Cabin lighting and navigation lighting
Windmill battery charger
(4) 2 year old house and starting batteries
Wind Vane steering
Transom mounted davits
Electronics and Navigational Equipment
Grace autopilot
Garmin 220 GPS
Danforth 5" compass
Combi digital depth sounder
(2) EPIRBs
Barometer and clock
Kiva digital compass
Loran "C"
Air/water temperature
Apelco radar LDR 9910
ICOM VHF
Sails and Rigging
(2) Serviceable mains
Furling genoa
Spinnaker with all gear
Staysail
Storm sail
Barlow primary and secondary winches
All sheets lead to the cockpit for short handed cruising
Remarks This Robert Perry designed Canoe Stern cutter is an Experienced World cruiser. With Trans-Atlantic, Black Sea and Mediterranean crossings she is a proven short handed Passage-maker. Unchallenged for the past 10 years she is lying in Florida waiting to be refurbished and off on a new adventure. Bring your wallet and your elbow grease. There are tons of spares and a room full of gear and sails.
To be frank this heavy duty passage maker is in need of upgrades and maintenance. It was used for its intended purpose by knowledgeable sailors and is proven in all seas and conditions. Outfitted with the best possible hardware for its journeys it has been unused for ten years lying in semi brackish water with little more than a "start up every month". The time has come for a new owner to prepare her for another passage-making adventure. Do you have what it takes?
Details and information regarding this vessel are offered in good faith but we cannot guarantee or warrant the accuracy
of this information nor warrant the condition of the vessel. A buyer should instruct his
agents, or his surveyors, to investigate such details as the buyer desires validated. This
vessel is offered subject to prior sale, price change, inventory change, or withdrawal
without notice.
Copyright 1992-2008 MarineSource Network, Inc.
"MarineSource" is a trademark of MarineSource Network, Inc., All Rights Reserved.
The unauthorized use of any spider, robot or other device, or the copying of any portion of this site without written permission is expressly forbidden.
Trademarks, Service Marks, and Copyrights are the property of their owners and are used for descriptive purposes only.
