3 Stateroom layout with one head. Forward V berth, 2 double aft cabins. Galley to port followed by Nav station. Settees port and starboard with center table.
Lewmar opening hatch with blind
(2) Opening portholes
Dining table with wood fiddles
U-shaped settee
Bar locker behind the settee back
Stowage under the settees
Pressure laminate flooring throughout interior
Lewmar opening deck hatch with blind
(2) Opening portholes on the coachroof
(2) Halogen overhead lights and (4) halogen reading lights
Storage cupboards behind settees
Large panoramic overhead fixed ports with blinds
The companionway steps hinge for access to the engine
Wood steps with anti-slip treads
(2) Wooden handrails
Sliding Plexiglass hatch
Companionway washboards with ventilation grill
Galley
(2) Burner LPG stove
Built-in shelf for microwave
Chest freezer
Cold plate Refrigeration 220 volt water cooled
Hot water heater
Cupboards with louvered inserts
Sink cover/cutting board
(1) Opening porthole above the stove
(1) Opening hatch
Stainless steel double sink with mixer tap, pressurized hot and cold water system
fire blanket
Head
Molded easy clean unit
Separate shower compartment with teak seat
Hand-held flexible shower unit
Toilet accessory holders
Electric sump pump for shower
Built-in washbasin with mixer tap, pressurized hot and cold water
Lewmar 30 CST maneuvering winch on the coachroof to port
Deck
Cored sandwich construction for stiffness, thermal and acoustic insulation and lighter weight. Solid fiberglass reinforcements are located in high load and hardware mounting locations. Unidirectional roving reinforced deck beams integral to the deck liner lamination are bonded to the deck for added strength. Bulkheads are bonded 360 degrees to the hull and deck for structural strength.
Stainless steel stern rail with horseshoe buoy holder and flagpole holder
6 X 24" Stainless steel stanchions with two sets of lifelines and gates
(2) Stainless grab rails on the coachroof
Extruded perforated aluminum toe rails
Stainless steel sternhead fitting with anchor roller and fairlead
(4) Fairleads on the beam and in the stern
(6) Anodized aluminum mooring cleats
Adjustable dorade-type vent for ventilation
Cockpit locker, life-raft stowage
Lazzarette locker
Locker for two gas bottles, complying with safety standards
Self-bailing cockpit
Pivoting patented wheel on pedestal with instrument panel
Compass and engine control lever on the steering pedestal
Removable wooden drop-leaf cockpit table
12 Volt console light
Engine instrument panel on coaming with protective Plexiglas cover
Access to swim platform by tilting helmsman's seat
Teak-inlaid transom skirt with protective rubber strip
Teak-inlaid swim platform
Stainless steel boarding ladder with plastic steps
Stern light
Teak inlaid cockpit seats
(2) Teak steps on coamings for access to the sidedecks
Winch handle holder
(2) Winch handles
GRP foot brace in middle of cockpit
Shore power receptacle on the transom
Hot and cold cockpit shower
(6) Life jackets
(4) Fenders
Hull Construction
Hand-laid solid GRP hull with a directional fiberglass/GRP structural hull liner. The hull is laid up with a vinyl ester barrier coat to resist osmotic blistering, followed by a zone-specific stitchmat laminate schedule to meet the specific strength requirements of each different section of the hull. The hull liner is laminated using high-strength non-woven stitchmat fiberglass and unidirectional rovings to achieve maximum structural distribution of all loads and forces while controlling weight. The completed hull and hull liner are bonded together using a proprietary polyester adhesive compound that chemically links the parts together.
Antifoul redone 11/2007
Bottom painted in December of 2007
Gelcoat polished in 2007
Keel: Cast iron bulb keel
Engine /Mechanical Equipment
Fitted Kiwi folding prop (works extremely well) and spare prop
NEW Gearbox 07
Oil for engine & gearbox changed 12/10/07
Fuel filter changed to Biodiesel
33 Gallon fuel tank
Engine compartment insulated with foam
Shaft protected by GRP skeg molded to the hull
Fixed 3-blade propeller
External engine instrument panel on coaming
Tachometer
Hourmeter
Fuel gauge
Electric sump pump and flow switch
Electric bilge pump
(2) Rigid water tanks
3 fire extinguishers
Electronics and Navigational Equipment
Garmin GPS
Raytheon ST60 Tridata
ICOM VHF with antenna
Stereo w/speakers
14 CD player
Garmin GPS
Forward facing chart table
Seat with stowage locker
(12) Functions 12V control panel
Opening panel for navigation instruments
Halogen overhead light
Red navigators light
Electrical System
Inverter for fridge to run at dock
Starter battery new 12/10/07
Two 12V batteries, 75 amp and 200 amp
110 Volt shore power system
6 110 Volt outlet
20 Amp battery charger
Shore power cord
Other Features
Extras include dishes, tools, flags, flares, medical kit.
Teak flagpole
Owner's manual
US duty has been paid
Remarks This is the 2003 Minneapolis Boatshow Showboat! Chartered in the BVI's and recently sailed to US. New sails and in nice condition. Pivoting Wheel in cockpit, 3 stateroom layout. Ready for new owner!
Details and information regarding this vessel are offered in good faith but we cannot guarantee or warrant the accuracy
of this information nor warrant the condition of the vessel. A buyer should instruct his
agents, or his surveyors, to investigate such details as the buyer desires validated. This
vessel is offered subject to prior sale, price change, inventory change, or withdrawal
without notice.
Copyright 1992-2008 MarineSource Network, Inc.
"MarineSource" is a trademark of MarineSource Network, Inc., All Rights Reserved.
The unauthorized use of any spider, robot or other device, or the copying of any portion of this site without written permission is expressly forbidden.
Trademarks, Service Marks, and Copyrights are the property of their owners and are used for descriptive purposes only.
